You are here: Home > Welding Gear & Accessories > SHEETMETAL > CRIMPER - SHEET METAL DOWNSPOUT
Sort By:
Page of 1
Klenk® Crimpers # MA71260 - FIVE BLADES OFFSET MODELS


  • Redesigned -- now available in straight and ergonomic, angled, offset models
  • Ideal for reducing diameter of round duct, sheet metal pipe, and downspouts for insertion into other pipes
  • Five blades make uniform crimps on sheet metal up to 20 gauge.
  • Recommended for light or heavy piping -- furnace, smoke, wall stacks, air ducts, water heater vent pipes, and downspouts
  • Crimps up to 1-5/8" back from end for good overlap connection
  • Heat treated blades for longer wear, hardened pivot bolt for durability, and non-slip grips for comfort
  • For natural indraw on metal, always start with the three blades on top.
  • Length
    Crimp Length
    Weight (lbs)
    9-3/4"
    1-5/8"
    1.125
Klenk® Crimpers # MA71250

Klenk® Five-blade Straight Crimper

  • Redesigned -- now available in straight and ergonomic, angled, offset models
  • Ideal for reducing diameter of round duct, sheet metal pipe, and downspouts for insertion into other pipes
  • Five blades make uniform crimps on sheet metal up to 20 gauge.
  • Recommended for light or heavy piping -- furnace, smoke, wall stacks, air ducts, water heater vent pipes, and downspouts
  • Crimps up to 1-5/8" back from end for good overlap connection
  • Heat treated blades for longer wear, hardened pivot bolt for durability, and non-slip grips for comfort
  • For natural indraw on metal, always start with the three blades on top.
  • Model # MA71250
    Klenk® Five-blade Straight Crimper

    Length
    Crimp Length
    Weight (lbs)
    9-3/4"
    1-5/8"
    1.125